Sell software your engineering students use on the model

This is for engineering educators and course creators who already sell to working engineers. Your students set up the model, run the load checks, size the members and write the calculation note, project after project. Software for engineering educators does those steps the way you teach them.

You keep teaching while we build the tool that does the analysis steps. FluentMint designs, builds, brands, hosts, maintains and supports it, and you sell it beside the course you already run. Tell us the struggle. If the fit is there, we scope the build at our cost.

The model work your engineers repeat

• Setting up a structural model the way your course shows.
• Running the load checks and recording the results.
• Sizing members with the same steps on every project.
• Writing the calculation note that goes with the model.

Software ideas for your engineering students

• Analysis workbenchThe engineer sets up the model using the method you teach, in software rather than a blank spreadsheet. The course steps are the controls.
• Load check calculatorThe software runs the load checks from your lessons and records the results. The engineer reviews the numbers instead of rebuilding the sheet.
• Member sizing toolThe engineer enters the member and the loads. The software applies the sizing steps you teach.
• Calculation note builderThe software writes the calculation note in the format your course uses. The note follows the model the engineer just ran.

Half of every sale beside the engineering course

Your engineers already pay for the structural analysis course. Sell them software that does the model work you teach, next to that course. FluentMint designs, builds, brands, hosts, maintains and supports it. You spread the word to your audience.

You pay nothing: €0 to build, run and license. No upfront cost, no software fees. Ever.

You keep 50% of every sale, upsells included, for the life of the customer. We handle maintenance and support tickets.

Questions